My ADSL modem was sitting on a music stand in the laundry And looking rather untidy with cables going every which way. A friend gave me the idea of making a custom shelf for it.
I have a load of jarrah paneling which was recovered from the Port Adelaide wool sheds in the 80s.
I took a piece of this, about 100 wide and 1200 long and cut it in three and jointed four edges. I then glued the two pieces together to make a piece that was about 250x400. I wanted the shelf to be about 200x300 wide. After resurfacing the faces on the thicknesser I cut out the piece to length and then cut it length wise which gave me one piece for the top then another which I could glue to the bottom of the back edge which I could use to secure the shelf to the wall.
I wanted a cut out at the back to take the cables so I made a template which would make about a 25x50 mm cut out on both pieces. This would allow all the cabes to be routed via the back of the shelf to keep it tidy. I had to buy a 40mm x 12 mm patten bit since my patten bit was not long enough. I secured the patten to the pieces using double sided tape and then routed out the recess.
I then routed a 12mm round over on all of the edges except for the front top of the rear piece and rear edges of the front piece where they joined and the back of the rear piece which sat against the wall. I then glued the rear piece to the bottom back of the top at right angles. Once the glue dried I Used a couple of pocket hole screws to reinforce the joint.
After scraping off the excess glue I used a small block plane to clean up any slight overlap of the joint.
I finally sanded to 320 grit using a random orbital sander and applied 2 coats of a home made wiping oil varnish mix. This left a film of oil after it dried so I wiped that off using a clean cotton rag and then applied a finishing wax which I buffed in by hand using a cotton rag.
I mounted it to the gyprock with some wall board fasteners. I did not bother locating it to the studs since the modem is just a few hundred grams.
The wood ended up with a nice deep red look with a natural finish. It is not subject to rough treatment so I thought that this was sufficient.
The finishing touch was some flexible cable ducting to keep it looking tidy.
It still has the marks of the various uses that the wood has had over the years which speaks of the history of the wood. I took no pains to disguise that since it does not detract from its purpose and adds character to the whole project.
I have more ideas for how to reuse the wood I have recovered as well as other unused pieces that the original owner and builder (now sadly passed) has left behind. All of the projects will have a similar character and I may even make a mounted plaque telling the story, just an idea at the moment.
My next project using this wood is a little more ambitious and will be a bathroom cabinet with glass doors.